SDPROG DASH MICRO K2 – DPF / FAP / GPF filter monitor

249.00 zł

SDPROG DASH MICRO is an intelligent device for monitoring DPF / FAP / GPF filter status, helping to avoid costly breakdowns and optimize vehicle use.

Connecting via OBD2, it analyzes real-time data and signals the filter status with an RGB LED and sound notifications. Colors indicate the level of contamination, and sound signals inform about the start and end of regeneration.

Main benefits:

  • Safety and economy – prevents damage to the engine and exhaust system.
  • Intuitive operation – simple installation without additional applications.
  • Compact and energy efficient – ​​automatic sleep mode minimizes energy consumption.
SKU: SDDASHMICROK2 Category: Tags:
SDPROG DASH MICRO – dioda zielona

Take care of your vehicle and avoid costly breakdowns!

Improper use of the vehicle, especially in situations where the exhaust filter (DPF, FAP, GPF) requires regeneration, can lead to serious problems:

  • Interrupting the burnout procedure: Shutting down the engine during regeneration can result in incomplete filter cleaning, which increases the risk of further failures.
  • Engine and exhaust system overload: Improper firing timing causes the vehicle to operate inefficiently, which can lead to increased fuel consumption and component damage.
  • Costly repairs: Improper use can cause problems that require expensive diagnostics and repairs.
SDPROG DASH MICRO – dioda niebieska

Benefits of using SDPROG DASH MICRO

  • Optimal use of the vehicle:
    The system provides current information on the filter status, allowing you to plan your journey accordingly. This allows you to choose a route or a time when filter regeneration will take place without interruption, avoiding sudden breaks in driving.
  • Safety and economy:
    Controlling the regeneration cycle helps avoid the risk of damage to the engine and exhaust system, which translates into lower repair costs and greater road safety.
  • Easy installation:
    Connect SDPROG DASH MICRO to the OBD2 connector – the device works immediately, without the need to install additional applications or perform complicated configuration.
  • Energy efficient and compact size:
    Thanks to the sleep mode, the device minimizes energy consumption, and its small dimensions allow for easy installation even in limited space. The device is very energy efficient, in sleep mode it draws only a few milliamps, so you don’t have to worry about the battery running out.

Check vehicle compatibility!

Vehicles marked K2 are being loaded...
BrandModelEngine

Intuitive visualization of the filter status as LED color signaling:

    1. Flashing blue: Attempting to connect to vehicle
    2. Flashing green: Very low soot level – after a few km the diode should change to a steady green. It may also indicate an attempt to read the soot level.
    3. Green: Low soot level – the filter is clean and ready to continue driving.
    4. Yellow: Filter partially clogged – it is time to prepare for the regeneration process.
    5. Red: High soot level – the filter is heavily contaminated.
    6. Flashing Red: Indicates that the burnout process is in progress. At this point, it is imperative that you continue driving to allow the regeneration procedure to complete – never interrupt the process by turning the vehicle off!
SDPROG DASH MICRO – sygnały dźwiękowe

Precise audio notifications

    1. Start of burnout: Four beeps indicate that the filter is now entering regeneration mode.
    2. End of procedure: Two beeps confirm that the firing is complete.

See how SDPROG DASH MICRO works

See the differences between DASH MICRO and SDPROG application

Related products